This procedure is available for 24 hours after enrollment with a panel and the device remains powered (battery installed). The PROSiXPANIC device self-deletes from the panel it was enrolled in. When successful, the LED comes back on flashing. If the device is enrolled in a panel different than the intended panel, and you are unable to delete it from the unintended panel, reset the device to factory default setting: Press and hold both buttons for 15 seconds. When removed from a system, the PROSiXPANIC will revert to factory default settings. Please note, the PROSiXPANIC cannot be used with another system until it is removed from the current controller. ![]() Once enrolled, verify adequate signal strength by conducting a sensor test. When done, the LED lights solid green for 3 seconds to confirm enrollment. The LED flashes green during enrollment and the device sends its unique MAC ID (Serial Number) and Services information to the controller. To enroll the PROSiXPANIC, set the controller in Programming Mode, press and hold the button for about 3 seconds until the LED flashes green to activate the enrollment process. The PROSiXPANIC has the following LED indications Green Flashing lights when unit is transmitting, Red Flashing lights indicate low battery (lights during button press). To clear memory of alarm, select Disarm and enter a user code. To clear the alarm at the control, enter a user code. The PROSiXPANIC wireless sensor is simple to activate, just press and hold both buttons briefly until the LED flashes. The PROSiXPANIC 2-button wireless sensor is compatible with the ProSeries PROA7, ProSeries PROA7C, ProSeries Canada PROA7CN, ProSeries PROA7PLUS, ProSeries PROA7PLUSC or ProSeries Canada PROA7PLUSCN all-in-one wireless touchscreen control panels. The Resideo Honeywell Home PROSiXPANIC is a wireless bi-directional panic sensor that is intended for use with control panels that support PROSiX-Series devices. Its loop number is "1.ProSeries PROSiXPANIC Product Description: The 5802WXT may be defined as Input Type "RF" (supervised RF, for an hourly check-in do not take out of range) or "UR"(Unsupervised RF). You must "enroll" the transmitter's serial number and loop number during system programming. When Programming the 5802WXT keep in mind it has a unique identification code (serial number) permanently assigned during manufacture. This transmitter can be programmed as any zone type response (e.g., Emergency Panics, Relay Action, etc.). ![]() ![]() I need help with installation I need help programming my thermostat I want to replace or buy a new thermostat My device isn’t working I need to find a manual T9 and T10 Firmware Update. The transmitter is supervised, i.e., it automatically sends a message to the control receiver that includes battery status information every 70-90 minutes. Thermostats Security Air Quality Water Leak Detector Apps. The 5802WXT is intended for use only with wireless alarm systems that support 5800-Series devices. Pressing and holding the transmitter button for two seconds sends a signal to the control receiver. The 5802WXT may also may be mounted to a desk, dresser, etc. The 5802WXT wireless personal panic transmitters provide DIYer's with an extra level of convenience, comfort and peace of mind. Both may be worn around the neck, on a wristband or as an apparel clip. There are two versions: the 5802WXT one-button transmitter and the 5802WXT-2 two-button transmitter. The Honeywell 5802WXT is a wireless personal panic transmitter that features a sleek, compact, water-resistant design, multi-wear accessories and more.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |